8 replies to this topic

[turbotorana]

just woundering wat these 2 fittings are for that are welded onto the intake pipe 1 is a threaded hole n the other is a piece of pipe 25mm in size witch is too small for a bov and the threaded fitting could only b for a sensor but what 1? have a look at fotos below u wil c them on the middle pipe which runs to the throttle body. thanks

i bought this as a kit from ase turbo had no instructions. mite ask them if i dont get any answers. thanks

any other info about installing the intercooler would b good like wat sensors i have to change do i need a 2 bar map sensor? and wat to do with the breather vac lines? thanks

Attached Files

•  satin%20finish.jpg   106.34K   12 downloads
•  intercooler-kit-gen-3-vt-vz.jpg   136.16K   10 downloads

[turbotorana]

engin bay

Attached Files

•  untitled.bmp   37.57K   10 downloads

[sinister]

I would probably say air intake temp. The map sensor is on the manifold, not the pipes. It sits on the top rear of the manifold. Depending on boost depends on what MAP sensor you need.

The fitting on the silver pipes is probably for the PCV. BOV as below.

Edited by sinister, 04 May 2011 - 05:56 PM.

[DAV133]

I got the same kit, one is sensor an the other is bov

[OSU55]

Threaded hole for the intake air temp sensor, have to buy a screw in sensor, 25mm pipe is for blow off valve, small bosch factory type one that most blower/turbo kits come with.
and you don't run any pcv, you need a catchcan setup and breath it to the air filter to make it legal if you want. You need to cut the car up a bit to fit the pipes in, but you will see that.
Get Dave to email you a fitting guide he will have some close up pics.

[DAV133]

Where abouts are u located my car is fully stripped if u wanna check it out to see where u gotta chop for cooler

I'm located in cairns

[turbotorana]

hey thanks guys im located in townsville, were would i get a screw in air temp sens is there a spec 1 for ls1 or just get 1 that fits the thread? i have a turbosmart bov which i want to use so i will get a bigger pipe welded on were the existing 1 is. boost should only b around 8-10psi so will i need a diff map sensor? and were from?anywere local? from wat i can c i should only have to cut abit out from under the head lights to make it fit. but any photos wold b great thanks for the help.

[DAV133]

Hey mate I got one pic on my phone if you pm your
Number I'll send it to you

[turbotorana]

Hey so any 1 no what I do with brake Booster vac line do I just leave it as is wil it b fine with boost pressure?is there any thing else I have to do with breather lines just move the PVC to the sc inlet.